Staff Members - Benha University
"Effect of γ -Al 2 O 3 /Water Nanofluid on Heat Transfer and Pressure Drop Characteristics of Shell and Coil Heat Exchanger With Different Coil Curvatures"Journal of Thermal Science and Engineering Applications, Vol 7, Dec. 2015
• 2015
Publication Information
Authors
Mohamed Reda Salem, R. K. Ali, Ramadan Sakr, K. M. Elshazly
Keywords
Not Available
Journal
Not Available
Publisher
Not Available
Volume
Not Available
Issue
Not Available
Pages
Not Available
publication.type
International
Paper Link
Open Link
Supplementary Materials
Not Available
Abstract
This study presents an experimental investigation of the characteristics of convective heat transfer in horizontal shell and coil heat exchangers in addition to the friction factor for fully developed flow through their helically coiled tube (HCT). Five heat exchangers of counterflow configuration were constructed with different HCT-curvature ratios (d) and tested at different mass flow rates and inlet temperatures of c-Al2O3/water nanofluid
in the HCT. The tests were performed for c-Al2O3 with average size of 40 nm and particles volume concentration (u) from 0% to 2% for 0:0392 d 0:1194. Totally, 750 test runs were performed from which the HCT-average Nusselt number (Nut) and fanning
friction factor (fc) were calculated. Results illustrated that Nut and fc of nanofluids are higher than those of the pure water at same flow condition, and this increase goes up with the increase in u. When u increases from 0% to 2%, the average increase in Nut is
of 59.4–81% at lower and higher HCT-Reynolds number, respectively, and the average increase in fc is of 25.7% and 27.4% at lower and higher HCT-Reynolds number, respectively,
when u increases from 0% to 2% for d ¼ 0:1194. In addition, results showed that Nut and fc increase by increasing coil curvature ratio. When d increases from 0.0392 to 0.1194 for u ¼ 2%, the average increase in Nut is of 130.2% and 87.2% at lower and higher HCT-Reynolds number, respectively, and a significant increase of 18.2–7.5% is obtained in the HCT-fanning friction factor at lower and higher HCT-Reynolds number,respectively. Correlations for Nut and fc as a function of the investigated parameters are obtained.
in the HCT. The tests were performed for c-Al2O3 with average size of 40 nm and particles volume concentration (u) from 0% to 2% for 0:0392 d 0:1194. Totally, 750 test runs were performed from which the HCT-average Nusselt number (Nut) and fanning
friction factor (fc) were calculated. Results illustrated that Nut and fc of nanofluids are higher than those of the pure water at same flow condition, and this increase goes up with the increase in u. When u increases from 0% to 2%, the average increase in Nut is
of 59.4–81% at lower and higher HCT-Reynolds number, respectively, and the average increase in fc is of 25.7% and 27.4% at lower and higher HCT-Reynolds number, respectively,
when u increases from 0% to 2% for d ¼ 0:1194. In addition, results showed that Nut and fc increase by increasing coil curvature ratio. When d increases from 0.0392 to 0.1194 for u ¼ 2%, the average increase in Nut is of 130.2% and 87.2% at lower and higher HCT-Reynolds number, respectively, and a significant increase of 18.2–7.5% is obtained in the HCT-fanning friction factor at lower and higher HCT-Reynolds number,respectively. Correlations for Nut and fc as a function of the investigated parameters are obtained.